The first is to purchase a ready-made in-wall cable kit (which doesn't cost a lot) so you easily run the wires through your wall. You're better off handling both types of cords the same way. You can take this approach with HDMI cables, but that still leaves the power cord to deal with. That's because directly running a power cord through a wall violates most building codes. Your initial thought about hiding the cables running from your monitor - simply drilling holes in the wall and snaking the cables from behind the screen to the floor - is not a good one. A couple of examples to look at: an adjustable full-motion wall mount for 13-42 inch screens and a heavy-duty fixed wall mount for 37-63 inch screens. That's all there is to it.Įvery mount is rated for screen size and weight (since, for example, a relatively small mount isn't going to be able to handle that 63-inch monster you've bought for your oversized living room), so be sure that the mount you purchase is appropriate for the size of your monitor. Use the included lag bolts and washers to hang the mount, position it exactly where you want it, tighten the bolts and hang the TV. Using a handheld stud finder, locate the two studs (usually 16 inches apart) where you want to place the mount, and then use the template that will come with your mounting hardware to mark the holes for drilling. The second type is a simpler, fixed wall mount which installs flush against the wall and is ideal for smaller rooms where there's no need to move the screen. These mounts are best for larger rooms where there are several different spots where people may want to sit. The first is the type that moves or swivels, allowing you to tilt or maneuver the TV so that it's positioned properly for the intended viewing area. There are two basic categories of wall mounts for flat-screen televisions. The overall task may seem daunting at first, particularly if you're not an accomplished carpenter or electrician. Hiding the cords is as important to the overall appearance of the room as hanging the television. That look is greatly diminished, though, if there are unsightly black power and HDMI cables running down the wall from a newly-installed monitor. Whether it's in the living room, a family room or the bedroom, a large-screen television placed in a prominent and optimal viewing spot on the wall gives any space a contemporary, finished appearance. Nothing puts a finishing touch on a modern room than a wall-mounted HDTV. Repeat this for any further cables.Back to Learning center DIY Guide: Hiding Cords On A Wall-Mounted TV Once you reach the top, pull enough through needed to plug into the TV and detach the string. Tie the bottom end of the string around your cable and start pulling the top end of the string so the cable starts feeding up behind the wall. Grab it and pull through, without letting go of the top of the string. Keep feeding down until you see it through the exit point (bottom hole). To feed the wires behind the wall, grab a long piece of string, longer than the gap between your entry and exit points and tie a weight (I used a drill bit) to one end, leaving enough string to tie to the wire, or the knot loose enough to undo.ĭrop this weight into the entry point (the top hole) and let gravity take the weight down behind the wall as you feed the string – don’t let go! Do this for both the entry and exit points, but don’t add the brush fronts just yet. Use the appropriate plasterboard rawl plug and screws to attach the plate. To attach the face plates, drill a hole where you marked the screw holes with a wood drill bit. You can either attach the face plates now, or after you feed the wires through the wall. Detach the wires from the TVĭetach the wires from your TV and get them ready to feed through.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |